Vacuum Cleaner Brushbar Motor Assembly Stock Number: ES1373267
Genuine spare part for select models of Dyson vacuum cleaners
Manufactured by Dyson
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Vacuum Cleaner Brushbar Motor Assembly
This part is the replacement motor which powers the brushbar in the head of your vacuum, so if yours has stopped spinning it could be due to this part being faulty. If this is the case, then pick up this genuine Dyson spare to restore your vacuum cleaner to its best.
Genuine spare part for select models of Dyson vacuum cleaners.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
8 Questions and 9 Answers
- there are 9 screws altogether 2 are under the rubber strip
- I cannot get into the motor assembly. I have taken out seven screws but it is still being held together.Sorry if I used the wrong terminology in my first question.
-
Chris at eSpares says...
This part is supplied as one piece from Dyson and may be 'glued' together as they do not supply any parts for this assembly.
how can i tell if it's the motor or circuitboard preventing the brush to rotate? i have pressed the reset button and still nothing 3 Answers
- How do you split the head housing, I have removed seven retaking screws, but there appears to be two more screws tucked away behind a nylon brush
- Please ensure you have removed the power from the machine before attempting the test advised. Sounds elementary but often overlooked.
- you just need a circut tester to check the motor,put the contacts on either side of brush housings if you get a reading then the motor is ok,if no reading then it could be brushes but it is more likely burnt out windings!,(new motor)ok,a.t.b. prezzer
-
Chris at eSpares says...
It is easier to test and identify a fault with the motor than a fault with the board. check for continuity across the motor.
- If you test the motor and that is working fine then its 99% that its the board and most people would not bother to try an repair it as it could be any number of things. If the cleaner is less that 5 years old they will replace the parts free.
-
Rory at eSpares says...
Hi TJ, the brushbar motor does not have a reset on it itself; the reset switch is located on the cleaner head, and a wire runs to the motor housing.
Will this part fit my appliance?
Check Now
