Tumble Dryer Heater Element - 2000W Stock Number: ES1435433
Genuine spare part for select models of Beko and Flavel tumble dryers
Manufactured by Beko
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Tumble Dryer Heating Element - 2000W
If your tumble dryer has not been adequately drying your clothes recently, you may have a problem with your dryer's heating element. If so, this replacement heater might just be what you need to get your tumble dryer back on the right track and have your laundry freshly warmed and comforting once more.
Specification:
- Wattage: 2000W
- Includes: safety thermostat
This genuine Beko spare is for select models of Beko and Flavel tumble dryers.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
13 Questions and 17 Answers
I have a DRCS 68W that is revolving and getting very hot but the clothes are just staying wet. Its like no air is circulating or something. I was hoping to find a fan or something as a part but none are listed. Not sure what part to replace, any ideas please?
- Thank you Chris, I had already cleaned the condensor and filter so I can eliminate that. The problem happened suddenly so i guess that also removes the filter from the suspect list. Thank you
-
Chris at eSpares says...
The belt goes round the outside of the drum down and around the motor spindle between the two belt tension wheels. These pinch the belt from either side to remove any slack and tension the belt.
-
Chris at eSpares says...
The part you refer to is not likely to be the problem. Dismantle the drier heater assembly on the top of the drum and check for signs of damage to the drier heater element.
-
Chris at eSpares says...
The first thing you need to do is check and clean the filter and the condenser at the bottom of the drier. Take the condenser out and flush warm water through to flush out any fluff or lint build up.
I have just ordered a new heater for the Beko DRCS68W. Looking at the back panel I'm unable to remove the cover that I think covers the heater as the panel has two pop rivets along with the screws holding the panel on. Do I have to drill out the rivets or 2 Answers
can I access the heater another way.
- Thankyou for the advice regarding the reset button on the blue wires!!
- The screws are all that holds the panel on - the panel will still come off with the rivets in place. Did you know the thermostat with the blue wires going to it has a reset button on it? I found out after I bought a replacement - not mentioned in the manual anywhare either!!
My drier appears to be working properly but it has no heat.Door closing drum rolling etc but no Herat.Disappointed as it is only 2 years old and not overused! 1 Answer
-
eSpares Staff at eSpares says...
It is likely to be the heater that has failed.
Does this heater unit come with the thermostat built in or do I have to get them separately ? 1 Answer
-
Dean at eSpares says...
We believe the thermostats are part of the element as shown in the photo attached to the part.
The little button on the heating element for my beko condenser dryer keeps tripping out after every use, its a brand new heating element. Any help would be great, many thanks 1 Answer
-
Dean at eSpares says...
There could be a number of reasons, please see our video for help http://www.espares.co.uk/advice/careandmaintenance/how-to-diagnose-tumble-dryer-drying-and-heating-problems
Will this part fit my appliance?
Check Now
