Tumble Dryer Heater Assembly Stock Number: ES1636648
Genuine spare part for select models of Beko tumble dryers
Manufactured by Original Quality Component
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Tumble Dryer Heater Assembly
If your clothes are coming out of the tumble dryer damp, don't write off your machine just yet! There's a good chance the problem lies within the heater assembly and eSpares could have just what you need to replace it. Before long your clothes will be coming back dry and warm.
Specification:
- Type: White NTC
- Wattage: 1600 + 700 Watts
- Thermostats pre-fitted
- Volts: 230V
Genuine spare part for select models of Beko tumble dryers.
Please check the list of suitable models to ensure that this spare part will fit your appliance.
11 Questions and 11 Answers
Hello, I am not sure what part I may need but my tumble dryer is tripping the RCD after running for a period of time and need some advice. 1) The pump is working as water is being collected 2) The condensor unit has been cleaned and free from debris 3) The drum is turning freely and so motor is ok 4) The machine is getting hot so the heater is working 5) The RCD does not trip straightaway and it appears to me that the machine may be overheating and this could possibly be causing RCD to trip after about 30 minutes or so. The time varies as it depends whats being dried and how much load there is. For example Towels create a lot of steam and heat and this will trip after about 20 minutes. The rear of the machine does feel very hot If its the mains filter would this not trip RCD immediately ? Could you possibly suggest what may be wrong
-
Ashleigh at eSpares says...
This could be caused by a number of things, please take a look at our Advice Centre: https://www.espares.co.uk/advice/symptom/tumble-dryer-tripping-or-blowing-the-electrics
Tumble stoped heating but would still work I stripped it down and the sensor had tripped. After resetting it and cleaning them it worked again but sensor keeps tripping out can the sensor be replaced as the heating element is working. Thanks 1 Answer
-
Chris at eSpares says...
The cut out thermostat shown in the third image is not listed as a separate part. If the dryer is turned off before it has finished the cool down cycle it can cause overheating as the air flow stops. Ensure you allow the cycle to finish before stopping the machine.
My tumble dryer is working but not drying. On the display is showing 9 min left to the end of the cycle but continue to spin an hours later. 1 Answer
-
Dean at eSpares says...
If the dryer is not heating then it is likely to be the element, if it has reached 9 mins which is the cool down it will have turned the element off. Most dryers will have an anti-crease function which continues to turn the drum after it has finished the program to stop the clothes from creasing.
I have tested the Element with a multi meter on a setting of 200k and I get a reading of 23.1. Does this signify a defective element as I only get a very low heat in the dryer?
-
Dean at eSpares says...
You need to test the heater on a low resistance setting, please see our video for more help diagnosing heater problems www.youtube.com/watch?v=trJXdqNBn7M just copy and paste into your browser.
My beko dcsc821w will start a cycle and keep going without getting hot. Would this be resolved with a new heater? 1 Answer
-
Dean at eSpares says...
Hi Robin, this does sound like it requires a new heater
Will this part fit my appliance?
Check Now
