Get The App From Play Store!

Skip to main content

Washing Machine/Dishwasher Cold Water Single Inlet Solenoid Valve Stock Number: ES188245

Genuine spare part for select Ariston, Creda, Hotpoint and Indesit washing machines/dishwashers

Read more

Manufactured by Hotpoint

(This part fits select models)

Will this part fit my Appliance?

Does it fit?
Enter your model number and select from the below list
Need help finding your appliance model number?

Check this part fits your appliance

2. Enter your model number

Washing Machine/Dishwasher Cold Water Single Inlet Solenoid Valve

If you are experiencing an issue with your washing machine or dishwasher not filling with water, it could be due to a faulty solenoid valve. The solenoid valve in your appliance is an electrical component that will open when current is applied to it - allowing the machine to fill with water from your household water supply.

Specification:

  • Angle: 180°
  • Type: 1 Way
  • Connector: Tag
  • Bore: 12mm
  • Cold Water Inlet

Genuine spare part for select Ariston, Creda, Hotpoint and Indesit washing machines/dishwashers.

Please check the suitable model fit list to ensure that this is the correct part for your appliance.

Ask a Question

4 Questions and 5 Answers

By up the Rossies - Ireland - 22 June 2011
  • Hi Rory Its the hot water valve for sure --the little plastic filter in the valve was filty and i thought i had solved the problem-------now its taking in water quicker than ever. before 1 inch of water in cylinder now 3 inches after been idle for 20 hours regards Up the Rossies By up the Rossies - Ireland - 28 June 2011
  • Rory from eSpares
    Rory at eSpares says...

    Hello there up the Rossies. It could be that either one of the other two valves is the cause - the ones on the end of the inlet hoses at the back of the machine. If the hoses are plumbed in to the kitchen sink, try turning your taps on and off to see if this has an effect on water entering the machine. If the leak stops happening while the taps are on, you'll need to replace the valve. The other thing that could be causing this is dirty or blocked filters inside the valves. Give all the filters a clean and get rid of any residue. Hopefully this'll sort it. Best of luck.

Answer this question
By Anonymous - brighton - 04 August 2014
  • Chris from eSpares
    Chris at eSpares says...

    The valve will work equally well on hot or cold water. The washing machine must have a cold water supply for rinsing.

Answer this question

Recently had to change our dishwasher lock (integrated Hotpoint BFI 680) but now when switching the dishwasher on, it will start normally and then give a short beep as though it's finished. When opening it, were getting flash lights which according to the manual is a clogged filter alarm but at other times the Water load solenoid valve. Dishwasher has only worked fully about 3 times without problems since changing the lock. We've cleaned the filter and don't think there's anything blocking it. Is it likely to be a filter or solenoid problem or could we have knocked a wire loose when changing the lock?

By Heavenly - Scotland - 01 August 2013
  • Chris from eSpares
    Chris at eSpares says...

    It is not likely that you have knocked the wiring but it is worth checking the connectors are fitted onto the control board properly. Check the spray arms are not blocked with rice or food particles.

Answer this question

It's a Hotpoint First Edition 1200 spin washer. There doesn't seem to be any power to it at all. It was working ok but then it stopped, I set it off again and it stayed on for ages, eventually I had to stop it manually. The water was red hot. The door will open even with water still in it but other than that nothing is working. Anyone got any ideas what it could be? I'd be grateful for any advice.

By Charlie - Lancashire - 03 August 2011
  • Likely to be the main programmer but no way to prove 100% without specialist test gear .If the machine is over 5 years old , consider a new machine or ask for an estimate from an authorised repairer . Good luck ! By dowser - dorset - 13 March 2012
Answer this question

Will this part fit my appliance?

Check Now

Washing Machine/Dishwasher Cold Water Single Inlet Solenoid Valve

11.25
(inc. VAT)
11.25