Dishwasher Cold Water Single Inlet Solenoid Valve Stock Number: ES571337
Genuine spare part for select models of AEG, Zanussi and many more brands of dishwashers
Manufactured by Electrolux
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Dishwasher Cold Water Single Inlet Solenoid Valve
If you've noticed your dishwasher is over or under-filling it could be due to a faulty solenoid valve. This electric inlet sits at the back of your dishwasher where the water supply enters and controls the flow of the machine. Grab this replacement from eSapres and get your dishwasher working at its best again.
Specification:
- Angle: 180 Degrees
- Type: 1 Way
- Connector: Tag
- Bore: 12 (mm)
- 220-240 Volts
- Cold Water Inlet
- Single Way Water Outlet
This is a genuine Electrolux spare part made to fit over 20 brands of dishwashers.
Please check the list of suitable models to ensure that this spare part will fit your appliance.
6 Questions and 5 Answers
-
eSpares Staff at eSpares says...
The most likely reason would be the valve has weakened and is letting in water so check the valve.
-
eSpares Staff at eSpares says...
Error code I30 on a Zanussi dishwasher refers to a water leak in the base activating the float switch, you will need to find where the leak is coming from.
Hi, I have trouble determing if my fill valve is dead or not. When I measure the resistance I get value of 4,3 kilo-ohms. What is the resistance of a new part?
-
Chris at eSpares says...
The resistance reading you quote is typical for this type of valve.
My Zanussi ZDT6244 dishwasher is not filling with water, I have changed the drain hose, the pump seems ok any ideas please? 1 Answer
-
Chris at eSpares says...
For information to diagnose your problem see our video: How to Diagnose Draining and Motor Problems in a dishwasher: www.espares.co.uk/advice/3/1889
Will not fill but if I tip the dishwasher forwards, then it WILL fill. When I stand the dishwasher level again it goes dead (stops filling and doesn't do anything else either). An engineer did come and look at it, and said the fill valve was OK so he's not sure what the problem is - do you think I should go ahead and change the valve anyway, or could it be something different? Will very much appreciate any help. Many thanks,
-
Rory at eSpares says...
Hi there, I'd advise checking the drainage system - it could be that there's a blockage there. The drainage system is situated in the base of the dishwasher; remove the lower basket - you should then see the drain sieve and drain filter.
Will this part fit my appliance?
Check Now
