Washing Machine NTC Temperature Sensor Stock Number: ES733255
Spare part for select Bosch, Neff & Siemens washing machines
Will this part fit my Appliance?
Check this part fits your appliance
Washing Machine NTC Sensor
The NTC sensor in your washing machine connects to the heater element, which ensures your washer is at the correct temperature whilst on a cycle. If your washing machine is not performing to the best of its ability, it may have a faulty sensor.
With the help from eSpares and this replacement NTC sensor, you could soon have a fully working washing machine again - ready to tackle the laundry!
Spare part for select Bosch, Neff & Siemens washing machines.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
18 Questions and 16 Answers
Can you buy the connector into the Ntc sensor as the wires have detached from the connector 1 Answer
-
Chris at eSpares says...
We cannot find a Bosch connection listed but believe this Stock Number ES1712265 has the same connection to the sensor and could be fitted to the existing cable
ive looked up on you tube it seems that if the ntc sensor is faulty it will pump out .machine goes into wash cycle but wont end.continually filling during cycle
-
Parminder at eSpares says...
Please view our advice centre page that covers common washing machine faults. Please see the link: http://www.espares.co.uk/advice/7/30 The models in this video may be different to yours, however the process should be similar for other makes and models.
wfc2467gb/10
-
Chris at eSpares says...
Check the water is supplied from a cold tap. If it is heating the water the problem must be the control panel.
Our Bosch washing machine finished a wash cycle and the clothes inside were left too hot to even touch. Do we need a new sensor?
-
Chris at eSpares says...
Check the inlet hose is connected to a cold supply. If the machine is heating during rinse and spin the problem is likely to be the heater. And If the machine is overloaded the washing can rub on the door seal causing friction.
My Bosch WFD 2471 runs through the wash cycles correctly but does not heat the water at all. The heater element reads 26 ohms (happy with that) and the NTC has a reading of 7.1kohms (not sure what this is supposed to be.) All wiring plugs look like they are fitted correctly. Can you please advise if the NTC reading is ok?
-
Chris at eSpares says...
If the machine complete a cycle it thinks it has heated the water (or does not need to) Run empty on a boil cycle to confirm if heating as with low temperature washing and low water levels some times you will not feel heat through the glass.
Will this part fit my appliance?
Check Now
