Get The App From Play Store!

Skip to main content

Tumble Dryer Thermostat Kit Stock Number: ES1063487

Genuine spare part for select models of Indesit, Hotpoint and Whirlpool tumble dryers

Product Q&A

Ask a Question

This not heating as hot as usual so taking much longer for the clothes to dry. Is this because one of the thermostats may have gone?

By BJ - Kent - 11 April 2015
  • Chris from eSpares
    Chris at eSpares says...

    For information to diagnose your problem see our video: How to Diagnose Tumble Drier Drying and Heating Problems http://www.espares.co.uk/advice/9/2050

Answer this question
By len - - 09 June 2014
  • Chris from eSpares
    Chris at eSpares says...

    the most likely cause is the heater or water getting on to the heater if it is a condenser dryer. See our tumble dryer diagnosis videos for more information.

Answer this question

I purchased and fitted these but still no joy. I have a technical question. Prior to ordering, I tested the 'one shot' with an avo and it did not conduct when I pressed it whereas the 'auto reset' did. I removed the 'one shot' and shorted the wires and the elements started to glow when the dryer was switched on. I onlt tested for literally 5 seconds. Confident that the one shot was faulty, I ordered this part but having now fitted it, it does not work i.e. still blowing cold. Strangely, the piece of paper that came with the rder describes a purple spot for the auto reset (mine is a 6kg vented after aug 96) but the auto reset that arrived has no spot. According to the paper, I may have the one that should be fitted to a 6kg condenser. Any thoughts appreciated.

By sgmiller - Edinburgh - 12 June 2009
  • I am stuck like you in that the description supplied with the part does not describe what they sent me. As there were no fitting instructions I don't know where to look to find the original faulty part so it may be what they sent me is what I need. By Lizzy123 - Londonish - 26 August 2009
Answer this question

my dryer sounds as if its working but its not getting hot at all, do you think it could be the sensors? Any suggestions would be of use please!

By cazzy1 - milton keynes - 02 February 2009
  • i would imagine that it is the sensors By cazzy1 - milton keynes - 13 February 2009
Answer this question

the model is a Hotpoint VTD20P.when drying it get so hot it cuts out and also the low temp does'nt work

By Stan - Sawnsea - 29 October 2011
Answer this question

The dryer trips out when the timer is induced for the heat mode.Will this product solve the problem?

By dice - - 30 August 2010
Answer this question

Will this part fit my appliance?

Check Now

Tumble Dryer Thermostat Kit

23.95
(inc. VAT)
23.95