Tumble Dryer Drum Assembly Stock Number: ES865672
Genuine spare part for select Ariston, Creda, Hotpoint, Indesit & Proline tumble dryers
I have a hotpoint aquaries TVM570 with a sheared drum shaft, do I need to replace whole drum as shafted is riverted in place?? If so is the right drum for me?? 1 Answer
-
Chris at eSpares says...
How to Replace 'New Style' Drum Shaft and Bearings in a Hotpoint or Indesit Tumble Dryer http://www.espares.co.uk/advice/9/2499
Hi i have a Hotpoint Experience 7kg model no TVEM70C6P with a sheared shaft, which part numbers do i require for the shaft and bearing also can i get the screws to fit as i have had to drill the rivets off the back plate to remove the old shaft. 1 Answer
-
Chris at eSpares says...
We believe the correct part you require is Stock Number: ES1672507
Model Hotpoint Aquarius TVAM70 CP/zuk Does the dryer drum assembly fit this model Thankyou Anne
-
Chris at eSpares says...
Yes but Stock Number: ES1562106 may repair your drum if the shaft is damaged.
Hi I have a indesit idv65 tumble dryer and the bearing has sheared. I've found the bearing is fixed to the drum is there any way of removing fixed shaft so I can replace with a new one. Cheers
-
Chris at eSpares says...
At this moment your existing drum is scrap however we believe you can drill out the rivets and use Stock Number: ES546701 kit to repair the dryer.
-
Chris at eSpares says...
Se our part kit Stock Number: ES546701 this has most of the common wear parts including the drum shaft.
I have a tumble dryer that the drum has failed at the attachment point. Could you please tell me which models of Creda tumble dryer that this drum fits.
-
Chris at eSpares says...
It is not unusual for the drum support pin to get damaged after the rear bearing wears through. Kit Stock Number: ES546701 would normally resolve most problems in this area. If you need a drum give us your model number as this drum may fit 50 models and it is not practical to list all of them here.
I have already ordered and received the drum shaft kit but the shaft replacement part is a screw fit but my original part is riveted to the drum. Can i drill out the rivets and replace with the new screw on part or would I have to replace the drum with a new drum and shaft fitted.
Will this part fit my appliance?
Check Now