Refrigerator Control PCB Module Stock Number: ES1247946
Genuine spare part for select models of Beko and Blomberg fridge freezers
Fridge very cold, back panel frozen, control module/ panel replace last year for same fault, been ok till now. 2 Answers
- Which is it likely to be. Cannot afford to get it wrong. There is white frost on top half of fridge and it freezes everything . Thanks
-
Chris at eSpares says...
Your problem will either be this PCB or the sensor that cannot be replaced as it is foamed into the insulation.
light comes on fan is running, but no cooling in fridge or freezer
-
eSpares Staff at eSpares says...
We have a video to help diagnose problems www.youtube.com/watch?v=duTWh83nVdA&t just copy and paste into your browser.
My beko gnev221apb fan is on. high humidity light is on I think the cold compressor comes on for a couple of seconds then goes off. It's not cooling or freezing. Can you help please 1 Answer
-
eSpares Staff at eSpares says...
Check the TOC which is located on the compressor and you will need to test the compressor with a multimeter to determine if it has failed.
Hi I have a beko cfd7914aps. Not getting cold, if i turn it off then on the compressor cuts in for 10mins or so then cuts out the interior fan will then cut in and out every few seconds and the compressor cuts out.. any ideas please 1 Answer
-
eSpares Staff at eSpares says...
We have a video to help diagnose the issue www.youtube.com/watch?v=duTWh83nVdA just copy and paste into your browser.
THE FRIDGE IS ICED UP AND UNABLE TO TURN DOWN.DOES THIS BOARD CONTAIN THE THERMOSTAT PLEASE 1 Answer
BEKO CFD6914APB
-
eSpares Staff at eSpares says...
No, the thermostat would be a separate part.
How can I determine if it is the Control PCB or Sensor which is turning my fridge into a freezer? 1 Answer
Beko fridge / freezer model number CDA648F
-
eSpares Staff at eSpares says...
It is likely to be either the control board or the sensor, the sensor is not replaceable as it is inside the foam lining but check the board for any signs of damage.
After a mains power failure the device is now stuck on defrost. When power is applied the compressor runs for about 5 seconds. There is a 'click' and the compressor stops and the cooling fan starts. This condition continues for hours.
-
eSpares Staff at eSpares says...
The click sounds like the TOC on the compressor is going out, check for any signs of damage and replace if required.
my beko fridge freezer suddenly stopped working ,high humidity indicator shows up on indicator panel. 1 Answer
fridge light is still on but neither freezer or fridge is working ,make beko, model number is gnev221apb,
-
Dean at eSpares says...
The humidity light on your Beko fridge indicates that there is high humidity (a large amount of moisture in the air) internally, which is good for keeping food fresh. It is normal for this light to be on.check the ventilation of the appliance as due to the hot weather it could be causing the issue.
Richard F says just unscrew the cover... The cover to what?
-
Dean at eSpares says...
We believe the PCB is located at the back of the appliance at the top, there will be a cover over the PCB held in with screws.
My fridge is freezing in the two top sections even though the temp switch is at the lowest. It's freezing my food in the bottom half. It's done this a few times before and I turned it off for a few days and it worked but it doesn't work this time.
-
Chris at eSpares says...
The problem is likely to be either this control board, or the sensor that cannot be replaced in the lining of the fridge.
Will this part fit my appliance?
Check Now